| From | Message |
Marc
9/01/2010
17:59:06
|
 Subject: Lanier LD050SPF error SC 350
IP: Logged
Message:
We were a Panasonic Dealer, but now have taken on Lanier, and Toshiba. I have a LD050SPF that is calling for service with an SC 350 about 2-4 times a day. I got a bulletin that said one cause was the transfer belt arm was out of place, I checked and that is not the problem. I have developer on order, but I'm not sure that will fix the problem.
Any help would be appreciated. TIA
|
i3fusionguy
9/01/2010
19:40:24
| RE: Lanier LD050SPF error SC 350
IP: Logged
Message:
From another board I loked up when I had this error (just started with copiers....yow...)
sc 350 is an id sensor error you can check this in sp mode 3103
and it will tell what the values are. Id sesor v should be 4v.It could be as simple as running id sensor voltage adjustment sp 3001-02 which automatically adjust id volt. Your problem could be a dirty id sensor however unlikely Drum cleaning problem would give poor id sensor voltage. cleaning dev roller and changing developer and drum would fix your problem.
Remember, clean the dev roller till its shiny. A green scrubby would do the trick.
|
Marc
9/01/2010
20:09:53
| RE: Lanier LD050SPF error SC 350
IP: Logged
Message:
Thanks for the reply, hopefully we have the parts stocked.
|
|
|