| From | Message |
Kenny
9/02/2010
20:59:28
|
 Subject: Sharp AR-287 Lead edge void adjustment?
IP: Logged
Message:
I got this machine sold and I had to mess with the registration. It was just a little off and you know how we like things to be on the money. I could kick myself. The lead edge was not all the way to the edge so I begin to adjust with sim 50-2 and I'm all over the place now. Please help anyone. These registrations have always been a thorn in my flesh! The book says set all to 0 and adjust but I don't know? If I get it fixed in time I might can deliver it tomorrow. It's not like all over the place like the clutches are bad. It's like if I could get it adjusted in the right way that would fix it. Thanks in advance.....
|
cpjim
9/03/2010
15:02:14
|  RE: Sharp AR-287 Lead edge void adjustment?
IP: Logged
Message:
adj. it exactly like the manual says and you might use 50-1 instead of 50-2, good luck.
|
Kenny
9/03/2010
15:50:07
| RE: Sharp AR-287 Lead edge void adjustment?
IP: Logged
Message:
Thanks cpjim I got it working but I'm still not so sure about it? Might mess up at any given time. Sometimes tring to understand these manuals is a job in itself? Thanks for the respond.
|