| From | Message |
Steve
9/03/2010
14:08:51
|
 Subject: Kyo CS-1820
IP: Logged
Message:
Refurbing one of these machines. Default codes do not work. Anyone know how to reset this to factory?
|
Home Boy
9/04/2010
06:15:18
| RE: Kyo CS-1820
IP: Logged
Message:
Never Tried this yet - out of the Manual -
Let me know if you cannot enter Maintenance Mode.
Maintenance item # - Sim U020 - Initializing All Data.
Description - initializes all backup RAM on the engine PWP to return to the original settings.
Purpose - used when replacing backup RAM on the engine PWP. After initialization, run U157 "Changing the developer drive time" and U411 "adjusting the scanner automatically".
Method - 1.Press the Enter Key. A selection item appears.
2. Select Execute using the Up/Down Cursor keys.
3. Press the Enter key. All data in the Backup Ram is initialized.
When initialization is complete turn the power switch Off and ON.
Completion - to Exit this maintenance item without executing initialization, press the Backup key. The indication for selecting a maintenance item # appears.
Running Sim U157 & U411 - likely, don't know yet.
Good Luck, Regards Home Boy.
|
Steve
9/07/2010
05:59:36
| RE: Kyo CS-1820
IP: Logged
Message:
Will not let me enter into any mode. Just a prompt for a user name and password. On any I have seen, can usually enter enter into system menu, but this one will not even allow that.
|
Elridge Andrews
9/18/2010
05:59:30
|  RE: Kyo CS-1820
IP: Logged
Message:
With copier on, open top cover where the toner goes and try enter sim that way.
|